#UNMOUNT APOLLO CLOUD 2 DUO SOFTWARE#

Press and hold “Volume-“ + “Power ON” keys for 15-20 seconds, Software will automatically close wizard window and will perform the reset FRP lock.Ģ.After Software request disconnect USB cable and connect Samsung Micro UART cable.Press “Reset FRP UART (UFS chips)” button.Put the phone in Download Mode (power off the phone, press and hold 'Volume-' + 'Home' + 'Power ON' buttons) and connect USB cable.To perform “Reset FRP UART (UFS chips)” operation, do the following steps: Need more help? Save time by starting your support request online and a technical support agent will be assigned to your case.Octoplus FRP Tool allows you to reset Google Factory Reset Protection (FRP) for Samsung, Huawei, LG, Alcatel, Motorola cell phones. Please always retrieve the PN from the battery's label.If the whole subsystem was shutdown, please manually turn ON the (2) PSU switches after replacing the batteries on both controllers.Īdditional Information – Battery PN (Part Number).Please check in the GUI or CLI to ensure the controller was recognized and it booted successfully.Wait for the controller to the boot completely.Insert the controller FRU to the enclosure.

Mount the top cover and the three screws.

Step 8 – Mount the Cover and Screws to the FRU

Caution: Carefully mount the battery to the 2 x 13 battery connector header on the controller.

Mount the new battery and proceed with the three screws on the battery module.

Step 7 – Mount the New Battery and Screws

Unmount the three screws to remove the battery:.

Unmount the three screws as illustrated in the (3) images below:.

To prevent EMI (Electromagnetic interference) damage to HW components, please wear electrostatic gloves and bracelet before replacing the battery.

Step 4 – Wear Electrostatic Gloves and Bracelet If any of the LEDs still remain ON or Flashing, please document a case with Technical Support.

#UNMOUNT APOLLO CLOUD 2 DUO PASSWORD#

If any LED remains ON or Flashing, please push ' Password Reset Switch (RSVD)' to interrupt the process.

Please wait (5) minutes to examine if the LEDs are turning off.

If any LED remains ON or Flashing, this signifies that the shutdown action did complete successfully and the controller is in a specific state (most likely, the controller is in C2F mode).

Once this has been verified, physically unplug the controller.

In normal conditions, all LEDs on the controller FRU (Field Replaceable Unit) will be turned off after the shutdown completes.

Step 3 – Check LED and Disable Battery Power

Unplug controller 1 to replace the battery.

During the shutdown process of the whole subsystem, the PSU will stop outputting after it completed its shutdown process.

Unplug the target controller when the GUI connection is lost or shows the specific controller is shutting down.

In the GUI, go to the Administration tab > Subsystem Information choose which Shutdown action you would like to apply to: Subsystem (both controllers), Controller 1, or Controller 2. In this example, we are shutting down Controller 1.

Shutdown the target controller or the entire subsystem.

#UNMOUNT APOLLO CLOUD 2 DUO HOW TO#

The scope of this document is to illustrate to a system administrator or technicians on how to properly replace the battery on the Promise E5000 Series.

Unmount apollo cloud 2 duo